APPLICATION GUIDE

How to Apply Specialty Transfers

Follow our heat press guide for a smooth finish with Falcon Specialty Transfers.

Shop Specialty Transfers
T-shirt showing a DTF transfer design
Temperature
310-330°F
Press Time
15 Seconds
Pressure
Medium–High
Peel
Cold Peel

PREPARE & WATCH

Before You Start

Have your equipments ready, then watch the application video to apply DTF Transfers.

What You’ll Need

  • Heat Press Machine Set to 310-330°F (depending on the transfer and garment) , Medium–High Pressure
  • Silicone Upper Platen CoverRecommended for Smooth Pressing & Garment Protection
  • Parchment Paper or Teflon Cover SheetNeeded final press & even heat distribution
  • Heat-Resistant Foam PadRecommended for Seams, Pockets, Hats, and Uneven Surfaces
  • Garment for Application
  • Falcon DTF TransfersInstant Peel Film
  • Thermal Heat TapeOptional – for precise placement

Apply Your Specialty Transfer in 6 Steps

Follow these steps for pressing, peeling and finishing your Falcon Instant Peel transfers.

  1. DTF transfer positioned on a charcoal garment before heat pressing

    Prepare the Garment

    Use a lint roller to remove any debris so the fabric is clean and smooth. Then pre press the fabric on its own for 4 to 5 seconds using medium to high pressure to remove moisture.

    Temperature: 320 to 330°F for Puff transfers, 310 to 320°F for all other Specialty transfers. Note: Make sure the fabric is fully dry. If it is not, repeat the pre press.
  2. Heat press positioned over a DTF transfer on a garment

    Position Your Transfer

    Some transfers have a thin protective layer on the back. If yours does, remove it first. Place the print on the fabric where you want it, with the design facing up. You can use our thermal tape to tape the transfer in place, ensuring a steady press.

  3. Carrier film being peeled from a DTF print on a charcoal garment

    Heat Press Your Transfer

    Press for 15 seconds using medium to firm pressure (30 to 40 psi).

    Temperature: 320 to 330°F for Puff transfers, 310 to 320°F for all other Specialty transfers. Note: Always test on a scrap piece first. Temperature and time may need adjusting based on your apparel, fabric type or heat press. Afterwards, let the design cool, then carefully remove the carrier sheet to reveal the design.
  4. Protective cover sheet placed over a DTF print for the final press

    Peel Off

    Let the design cool, then carefully remove the carrier sheet to reveal the design.

    Note: Wait 24 hours before washing the garment.

TRY FALCON TRANSFERS

See It. Press It. Love It.

Try our DTF transfers with a free sample pack.

DTF sample pack illustration with colorful transfer designs
Get a Free Sample Pack

Your Next Project Starts Here

Choose the ordering option that works for you.

Need a different application guide?